Electro Industries Shark 200T Especificaciones descargar pdf (Pagina 60)

Doc# E149701 4 - 4

4: Electrical Installation

Electro Industries/GaugeTech

The Leader In Power Monitoring and Smart Grid Solutions

Electro Industries/GaugeTech

The Leader In Power Monitoring and Smart Grid Solutions

4.2: CT Leads Terminated to Meter

The Shark® 200 meter is designed to have current inputs wired in one of three ways.

Figure 4.1 shows the most typical connection where CT Leads are terminated to the

meter at the current gills. This connection uses nickel-plated brass studs (current

gills) with screws at each end. This connection allows the CT wires to be terminated

using either an “O” or a “U” lug. Tighten the screws with a #2 Phillips screwdriver. The

maximum installation torque is 1 Newton-Meter.

Other current connections are shown in figures 4.2 and 4.3. Voltage and RS485/KYZ

connections are shown in Figure 4.4.

Figure 4.1: CT Leads Terminated to Meter, #8 Screw for Lug Connection

Wiring Diagrams are shown in Section 4.8 of this chapter.

Communications connections are detailed in Chapter 5.

$VSSFOUHJMMT

OJDLFMQMBUFE

CSBTTTUVET

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 297 298

Sin comentarios

Electro Industries Shark 200T Especificaciones Pagina 60